Q: How long does gutter installation take?

For most homes, professional gutter installation takes about 4–8 hours , meaning it’s typically completed in one day . A straightforward single-story home with roughly 150–200 linear feet of gutters might take 3–5 hours . A larger two-story home, steep roof, lots of corners, or complicated rooflines can take 6–10 hours or occasionally extend into a second day. A few things can add time: removing and disposing of old gutters, replacing damaged fascia, installing gutter guards, adding additional downspouts, difficult access, and custom details. For a seamless gutter installation, much of the work is done right at the property. The gutter machine forms each run to the required length, then the crew cuts miters/outlets, installs the gutters with the correct pitch, and installs the downspouts. A note from Jason: “Most gutter installations are completed in one day. Larger or more complex homes may take a little longer, but we’ll let you know what to expect before we begin.”

Q: Do you replace fascia before installing gutters?

Yes— if the fascia is rotten, soft, damaged, or unable to securely hold the gutter , it should be repaired or replaced before the new gutters are installed . You don’t necessarily need to replace all the fascia just because you’re getting new gutters. A good installer should inspect it after the old gutters come down and determine whether it’s structurally sound. A typical sequence is: Remove the existing gutters. Inspect the fascia for rot, water damage, splitting, or loose areas. Repair or replace damaged fascia as needed. Prime/paint or wrap the new fascia when appropriate. Install the new gutters into solid material with proper pitch and fastening. This matters because gutters can get very heavy when they’re full of water, snow, ice, or debris . Installing brand-new gutters onto deteriorated fascia can result in loose fasteners, sagging gutters, incorrect pitch, or eventually the gutter pulling away from the house. For Boise homes in particular, I’d pay attention to older wood fascia and areas beneath roof valleys , where years of overflowing water can cause hidden deterioration.

Q: Do gutter guards work with pine needles?

Yes, but choosing the right gutter guard is important. Pine needles are thin and can pass through or become stuck in many traditional screens and perforated gutter covers. For homes surrounded by pine trees, we recommend a high-quality fine-mesh gutter protection system designed to keep pine needles and smaller debris out while allowing rainwater to flow into the gutter. While no gutter guard eliminates maintenance completely, the right system can significantly reduce the amount of debris entering your gutters and make routine maintenance much easier.

Q: What gutter colors are available?

We offer a wide range of seamless gutter colors to match or complement your home’s exterior, including popular options like white, black, bronze, brown, gray, and tan . Choosing the right gutter color helps your system either blend in with your fascia and trim for a clean, seamless look or stand out as a design accent that enhances curb appeal. Color options may vary by material and supplier, so contact us to view current availability and find the best match for your home’s roof, siding, and trim.

Question 1

How much do seamless gutters cost in boise?

Accepted Answer

Our pricing is determined by the size of the gutters, either 5" or 6", and calculated by the linear foot. We ensure transparent and upfront pricing prior to commencing any work, eliminating unexpected costs. Please contact us to discuss the specifics of your project.

Question 2

Are 6-inch gutters worth it in Idaho?

Accepted Answer

Yes. In the Boise, 6" gutters are often worth it, especially on newer/larger homes, steep or complex roofs, and long gutter runs.

Compared with standard 5" K-style gutters, a 6" system can handle roughly 40-50% more water, depending on the exact profile and installation. Boise doesn't get extreme annual rainfall, but the bigger reasons to consider 6" are short, intense thunderstorms, snowmelt, roof valleys, and concentrated runoff.

For a typical Boise-area house, I'd recommend 6" when the home has a steep roof, large roof sections draining to one run, multiple valleys dumping into the same gutter, two-story sections that are difficult to access, or a history of overflowing. They're also a good fit with a larger 3X4 downspouts, which reduces bottlenecks and clogging.

On a smaller, simple ranch-style home with properly pitched gutters and enough downspouts, 5" gutters can be completely adequate, so I wouldn't tell every homeowner they need 6". The installation design-outlet size, downspout placement, pitch and number of drainage points-matters just as much as gutter width.

Question 3

5" vs. 6" gutters — which should I choose?

Accepted Answer

For most homeowners, I’d make the choice based on the roof, not just the gutter size. In Boise, 5-inch gutters are adequate for many homes, but 6-inch gutters are the better choice when the roof puts a lot of water into a limited number of drainage points.

I’d choose 5-inch if…

You have a smaller or average-sized home, relatively simple rooflines, shorter gutter runs, and plenty of downspouts. If properly sized and installed, there’s nothing inherently wrong with 5-inch gutters.

I’d choose 6-inch if…

You have a large or steep roof, long gutter runs, multiple valleys, big sections of roof dumping into one area, or you’ve experienced overflowing gutters before. I’d also lean toward 6-inch if the price difference isn’t substantial.

One overlooked advantage is the 3×4 downspout commonly paired with 6-inch gutters. It has about twice the cross-sectional area of a 2×3 downspout (12 sq. in. versus 6 sq. in.), so leaves and debris have a larger path through the system.

For Boise specifically

Boise isn’t an especially rainy climate, so 6-inch gutters aren’t automatically necessary. But our thunderstorms, snow accumulation/melt, and increasingly large/complex residential roofs can create concentrated runoff. That’s where 6-inch systems make sense.

My rule of thumb: If you’re replacing gutters anyway and the upgrade to 6-inch is reasonably priced, I’d usually choose 6-inch with 3×4 downspouts on a modern Boise home. You’re buying additional drainage capacity and a larger outlet for relatively little additional visual bulk.

If you’re comparing quotes for 5” vs. 6” gutters, give me the house square footage, number of stories, and approximate roof pitch (or send me a picture of the house), and I can tell you whether I’d actually spend the extra money on 6-inch for that particular house.

Question 4

Do you install gutters on new construction?

Accepted Answer

Yes! We install seamless gutter systems on new-construction homes. We work with homeowners, builders, and contractors to ensure the gutters and downspouts are properly sized and positioned for the home’s roof and drainage needs.

For the best results, gutters are typically installed after the roof, fascia, and exterior finishes are complete. We can coordinate with your construction schedule to make sure your gutter system is installed at the right time.

Question 5

How long does gutter installation take?

Accepted Answer

For most homes, professional gutter installation takes about 4–8 hours, meaning it’s typically completed in one day.

A straightforward single-story home with roughly 150–200 linear feet of gutters might take 3–5 hours. A larger two-story home, steep roof, lots of corners, or complicated rooflines can take 6–10 hours or occasionally extend into a second day.

A few things can add time: removing and disposing of old gutters, replacing damaged fascia, installing gutter guards, adding additional downspouts, difficult access, and custom details.

For a seamless gutter installation, much of the work is done right at the property. The gutter machine forms each run to the required length, then the crew cuts miters/outlets, installs the gutters with the correct pitch, and installs the downspouts.

A note from Jason:

“Most gutter installations are completed in one day. Larger or more complex homes may take a little longer, but we’ll let you know what to expect before we begin.”

Question 6

Do you replace fascia before installing gutters?

Accepted Answer

Yes—if the fascia is rotten, soft, damaged, or unable to securely hold the gutter, it should be repaired or replaced before the new gutters are installed.

You don’t necessarily need to replace all the fascia just because you’re getting new gutters. A good installer should inspect it after the old gutters come down and determine whether it’s structurally sound.

A typical sequence is:

Remove the existing gutters.
Inspect the fascia for rot, water damage, splitting, or loose areas.
Repair or replace damaged fascia as needed.
Prime/paint or wrap the new fascia when appropriate.
Install the new gutters into solid material with proper pitch and fastening.

This matters because gutters can get very heavy when they’re full of water, snow, ice, or debris. Installing brand-new gutters onto deteriorated fascia can result in loose fasteners, sagging gutters, incorrect pitch, or eventually the gutter pulling away from the house.

For Boise homes in particular, I’d pay attention to older wood fascia and areas beneath roof valleys, where years of overflowing water can cause hidden deterioration.

Question 7

How often should gutters be cleaned in Boise?

Accepted Answer

We recommend cleaning your gutters at least twice a year—typically in the spring and again in late fall after the leaves have dropped. If your home is surrounded by mature trees or pine trees, your gutters may need to be cleaned more frequently.

Regular gutter cleaning helps prevent clogs, overflowing water, fascia damage, and drainage problems around your home’s foundation. Keeping your gutters clear is one of the simplest ways to extend the life of your gutter system.

Question 8

Do gutter guards work with pine needles?

Accepted Answer

Yes, but choosing the right gutter guard is important. Pine needles are thin and can pass through or become stuck in many traditional screens and perforated gutter covers.

For homes surrounded by pine trees, we recommend a high-quality fine-mesh gutter protection system designed to keep pine needles and smaller debris out while allowing rainwater to flow into the gutter.

While no gutter guard eliminates maintenance completely, the right system can significantly reduce the amount of debris entering your gutters and make routine maintenance much easier.

Question 9

What gutter colors are available?

Accepted Answer

We offer a wide range of seamless gutter colors to match or complement your home’s exterior, including popular options like white, black, bronze, brown, gray, and tan.

Choosing the right gutter color helps your system either blend in with your fascia and trim for a clean, seamless look or stand out as a design accent that enhances curb appeal.

Color options may vary by material and supplier, so contact us to view current availability and find the best match for your home’s roof, siding, and trim.

Question 10

How do I get in contact with you?

Accepted Answer

If you’d like to get scheduled in with us, please fill out our request form. Once we’ve received the details of what you’re looking for, we’ll reach out to discuss next steps.

Seamless Gutter Installation & Repair in Boise, Idaho

Drip Free Gutter Company provides seamless gutter installation, replacement, repair, cleaning and gutter guards throughout Boise and the Treasure Valley.

Gutter Services

Residential Gutter Installation

Commercial Gutters

Gutter Replacement

Gutter Repair

Gutter Guards

Gutter Cleaning

Fascia & Soffit

Reviews

Our work

About us

Frequently asked questions

How much do seamless gutters cost in boise?

Are 6-inch gutters worth it in Idaho?

5" vs. 6" gutters — which should I choose?

Do you install gutters on new construction?

How long does gutter installation take?

Do you replace fascia before installing gutters?

How often should gutters be cleaned in Boise?

Do gutter guards work with pine needles?

What gutter colors are available?

How do I get in contact with you?

Get an Estimate

No leaks. No worries. Just Drip Free perfection 💧

Seamless Gutter Installation & Repair in Boise, Idaho

Drip Free Gutter Company provides seamless gutter installation, replacement, repair, cleaning and gutter guards throughout Boise and the Treasure Valley.

Gutter Services

Residential Gutter Installation

Commercial Gutters

Gutter Replacement

Gutter Repair

Gutter Guards

Gutter Cleaning

Fascia & Soffit

Reviews

Our work

About us

Frequently asked questions

Question

How much do seamless gutters cost in boise?

Question

Are 6-inch gutters worth it in Idaho?

Question

5" vs. 6" gutters — which should I choose?

Question

Do you install gutters on new construction?

Question

How long does gutter installation take?

Question

Do you replace fascia before installing gutters?

Question

How often should gutters be cleaned in Boise?

Question

Do gutter guards work with pine needles?

Question

What gutter colors are available?

Question

How do I get in contact with you?

Get an Estimate

No leaks. No worries. Just Drip Free perfection 💧